Roman Aqueducts :: essays research papers

Ancient Rome had football team major aqueducts, built between 312 B.C. (Aqua Appia) and 226 A.D. (Aqua Alexandria) the longest (Anio Novus) was 59 miles long. It has been calculated that in imperial times, when the citys population was well over a million, the dissemination musical arrangement was able to provide over one cubic meter of body of water system per day for each inhabitant more(prenominal) than we use nowadays. For virtually of their space the early aqueducts were simply ducts bored through the rock, from the water ambition in the hills almost to the distribution cistern in Rome. The depth of the channel below ground varied so as to maintain a constant, very shallow gradient (less than 1/200) throughout the aloofness of the aqueduct perpendicular shafts were bored at intervals to provide ventilation and access. Only in the last(a) stretches was the conduit raised on arches, to give a sufficient head for distribution of the water within the city. In order to k eep the gradient constant, the aqueducts took a roundabout route, following the contours of the land and heading along spurs which led towards Rome. The most dramatic parts of a Roman aqueduct wereand still arethe bridge (also known as arcades) that carried the water over low spots in the terrain. Perhaps the best-known of these is the Pont du Gard, a part of the aqueduct that served the town in Nmes in Gaul (todays France). The bridge stands on three tiers of arches and has a length of 274 m (900 ft). Built without the use of mortar, it stands 49 m (160 ft) in a higher place the born(p)gre Ravine. Another famous Roman aqueduct is the one in Segovia, Spain it still carries water, although it did hire restoration in the 15th century. s time went on, Roman engineers became more daring in the construction of high arches to support the conduits a hybridization valleys and plains and some of the later aqueducts were as much as 27 meters (about 100 feet) above ground direct in places. Closed pipes were occasionally used to cross valleys by the "inverted syphon" method the pressure forced the water down and up again on the other side, to a level slightly lower than before. But this system was costly, as it required maneuver pipes (lead had to be imported from Spain or Great Britain) and it was difficult to make joints strong enough to withstand the pressure so arches were far more common.